常州附近想过夜电话联系

One stop service provider for production, installation and commissioning of shot blasting machine

Shot blasting machine | shot blasting cleaning machine | through shot blasting machine source strength manufacturers

Your location: > common problem >

National Service Hotline

fifteen billion two hundred and sixty-nine million two hundred and four thousand seven hundred and seventy-seven

How to install and maintain hook shot blasting machine correctly

Author: admin Source: This station Time: April 4, 2017 18:37
Shot blasting machine How to install it Hook type shot blasting machine , hook type Shot blasting Rust remover What problems should be paid attention to during the installation of hook type shot blasting equipment? If you need to renovate or repair the hook type shot blasting machine, please contact us, we will provide you with the installation and maintenance team of shot blasting machine, professional knowledge and professional attitude to serve you free of charge.
?
 How to install and maintain hook shot blasting machine correctly
1. Installation of the machine
?
(1) The volume of the machine is limited by the transportation conditions and can not be assembled and delivered from the factory. Therefore, the machine is delivered to the user's site for installation in groups and boxes. The user must shape the machine according to his / her own discretion and pay attention to the technical requirements in the drawings.
?
(2) Before installation, the foundation shall be prepared in advance, and the general assembly can be carried out after the foundation is dried, and the foundation bolt pit shall be reserved for secondary pouring.
?
(3) During the final assembly, the cleaning chamber shall be fixed first, and then the shot blasting device, rail and hook hoist, separator, shot supply system, electrical components, etc. shall be assembled according to the general drawing size.
?
(4) The sprocket cover is welded on the elevator after it is in the upper position during general assembly.
?
(5) The position of the directional sleeve window should be adjusted according to the projection range.
 How to install and maintain hook shot blasting machine correctly
2. Adjustment of the machine
?
After the whole machine is installed (or used for a period of time)
?
(1) To adjust the directional sleeve in the shot blaster, release the pressure block of the directional sleeve, and then rotate the directional sleeve back and forth, so as to change the position of the window of the directional sleeve to change the shot ejection position, that is, adjust the directional sleeve along the rotation direction of the shot blaster, and the ejection position moves forward, otherwise, the ejection position moves backward.
?
(2) Adjust the electric gate to achieve the required shot supply flow.
?
(3) When the belt of the elevator is loose, the bolts on the upper part of the elevator can be adjusted to ensure the proper tightness of the belt.
?
(4) The tension of the upper chain of the hoist is adjusted by the reducer motor.
?
(5) The wind speed in the separator can be adjusted to a suitable position.
?
3. Operation of the machine
?
After the operation of all parts of the machine meets the requirements, the whole machine can be idled and loaded for trial operation. After the separator and elevator are started, the shot to be added shall be gradually added from the conveying shell, so that it is transported to the pellet storage bucket of the separator. Carry out the test run according to the operation procedure of the machine. If any abnormal phenomenon is found during the operation, the machine shall be shut down immediately and the test shall be conducted again after commissioning and repair.
Next: no more